Pumps with internal damage or lost prime
HEYIRRIGATIONWeston · Broward County
Irrigation and Sprinkler Service in Weston
In Weston we work with residential systems that depend on pumps, relays and multiple zones. A water-source failure can resemble a coverage problem, so we inspect the system as a whole.
When to request an evaluation
Common problems in Weston.
Relay that does not start the pump correctly
Insufficient coverage across large areas
Old or difficult-to-program controllers
Complete service
Residential irrigation solutions in Weston.
We also modernize controls and zone distribution when an older system operates inconsistently.
Sprinkler repair
View service →Irrigation pumps
View service →Electric valves
View service →Wi-Fi controllers
View service →New irrigation systems
View service →Information for Weston
Complete diagnosis from the source to the last head
Weston systems may include pumps, relays and large zones. A weak pump or air entry can reduce the radius of every head and resemble several independent failures.
We compare zone behavior to distinguish a general failure from a localized problem. We also check whether the controller sends the correct signal to the relay and valves.
When a pump is replaced, testing does not end when it turns on. We confirm prime, water movement, pressure and zone operation.
What to expect
A clear process from start to finish.
Source and pump
We verify prime, suction and response under demand.
Electrical control
We check controller, relay and valve activation.
Distribution
We observe pressure and coverage in every active zone.
Important: A complete evaluation helps avoid replacing heads when the real cause is the water source or pump.
Frequently asked questions
Clear answers before service.
Can you inspect the pump and sprinklers in the same visit?
Yes. The evaluation can include the water source, pump, relay, valves, zones and controller.
Can a damaged pump affect only some zones?
Yes. Zones with greater demand or longer runs may show performance loss first.
Do you test the pump start relay?
Yes. We confirm it receives the controller signal and supplies the required power to the pump.
Does your system need attention?
Tell us what is happening and where the property is located.